Back to All Events

Flow Meter Installation Certification Training Dates

Flow Meter Installation Certification Training

These training sessions are intended for individuals who would like to install their own flow meters.  Each training session listed below will certify an individual for that specific brand of flow meter only.

You need only attend the training session(s) that corresponds to the type of meter(s) that you plan to install. An individual would need to attend each of the five training sessions to be certified to install all five meters on the Lower Elkhorn NRD approved list. 

Each Days Training Schedule:

Session 1:  9:00 am – 9:45 am      Senninger Flo-Wise Ag Rotor Sensor System

Session 2:  10:00 am - 11:00 am McCrometer Propeller Flowmeters (All Models)

Session 3:  11:15 am – Noon      McCrometer McMag 3000 Magmeter

***Lunch is on your own from Noon to 1:00pm

Session 4:  1:00 pm – 1:45 pm     Seametrics AG 2000 Series Magmeter

Session 5:  2:00 pm – 2:45 pm     Growsmart by Lindsay IM3000 Magnetic Flow Meter

Training Dates and Locations:

  • Date:  November 16th, 2016
  • Location:  Cuming County Courthouse Lower Level Meeting Room, 200 S. Lincoln, West Point, NE
  • RSVP:  No RSVP necessary for this site.
  • Date:  November 22nd, 2016
  • Location:  Village of Pilger Clerk’s Office, 220 N. Main, Pilger, NE
  • RSVP:  Space is limited at this site. Please RSVP to the Lower Elkhorn NRD at 402-371-7313 if you are going to attend this training.
  • Date:  November 29th, 2016
  • Location:  Legion Lounge & Backroom Steakhouse, 109 West Main St., Pierce, NE
  • RSVP:  No RSVP necessary for this site.
Earlier Event: November 22
Board Meeting - LENRD office
Later Event: December 8
Committee Meeting - LENRD office